- #Deleting clover efi pdf#
- #Deleting clover efi serial#
- #Deleting clover efi driver#
- #Deleting clover efi series#
Graphic Cards 1) Intel HD Graphics 4000 2) NVIDIA GeForce GT640M LE Hard Disks 1 SSD 120GB (KINGSTON SHFS37A120G) in a caddy which replaced the original DVD writer/BlueRay reader, 1 HDD 750GB (WDC WD7500BPVT)
#Deleting clover efi pdf#
The system runs reliably and much faster that my 2015 iMac! Once setup, there's really not much maintenance, apart from the occasional Clover and kext refresh prior to a macOS update.Or you can download the PDF file with the instructions and follow them I am happy to have learned something new and I am satisfied with the results. The system seems not respond and you may be tempted to force a shutdown: please don't, just be patient! The system is not blocked, it will eventually restart after 10-20 minutes with the updates correctly installed. The progress bar got stuck at zero progress and showing 12 or 13 minutes remaining. They eventually installed without problems, but I encountered a strange behaviour. I run the updates as I would do on my normal Mac. After that, two updates for 10.14.6 were released. Check again in System Report that "TRIM Support: YES" If "TRIM Support: NO" then run "sudo trimforce enable" from Terminal and follow the instructions on the screen. You can check your drive by opening System Report/Sata or System Report/NVMExpres. I left it enabled and all seems to be working fine.
#Deleting clover efi driver#
This single change enabled the use of the standard driver OsxAptioFix3Drv.efi With the standard setting (64M), I can only boot with the unsupported OsxAptioFix2Drv-free2000.efi (see above) Enable Internal Graphics (we use the Radeon, but we need this for HW acceleration).USB configuration: enable XHCI Hand-off.Save&Exit: Load Optimised Defaults and confirm.I tried to stay with the Optimised Defaults to the extent possible, and changed just four settings. I am on BIOS revision F7, the latest available at the time of writing. If you want to enable it to see what's happening behind the scene, just add the -v argument in Boot/Arguments. I have removed the verbose boot as the system is now very stable and I do not have to troubleshoot. I am using iMac 19,2 in SMBIOS: you may want to change that if you use different hardware, especially a different CPU generation.
#Deleting clover efi serial#
The Kernel and Kext Patches section is de facto disabled (no need for a USB patch, as we have a custom USB kext), but I had to keep the section as a placeholder or the system will not boot.īefore you can use this plist file, you have to customise it with your generated Serial Number, Board Serial Number, UUID and MLB (Please refer to the general instructions above). Entire sections (Acpi, Boot Graphics, CPU, Devices, Disable Drivers, Gui) have been completely removed or cut to the bone. If you plan to use the Integrated Graphic card only, you can use this post to get some ideas but will definitely have to use different BIOS and Clover settings to make it work.
#Deleting clover efi series#
Should you have a similar Radeon card from the same series (say an RX 560 or RX580), you should still be able to use this configuration. it does not drive a monitor but provides encoding hardware acceleration to Mojave via Intel Quick Sync. The embedded Intel IGPU is used in "headless mode", i.e. I am using a Sapphire Pulse RX570, which is in the recommended list from Apple, connected via Display Port. The Clover configuration proposed in this post is valid only with a discrete graphic card. VideoProc Hardware Info to check Quick Sync acceleration Sources and General Instructions for Vanilla Installation This should ensure maximum support with Clover also for the future.